Safety Instructions; User Manual - Toolland TM91001 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2.

Safety Instructions

When using the machine, always observe the enclosed safety instructions as well as the additional safety
instructions.
Keep the work area clean. Cluttered areas and benches invite injuries.
•
Keep children away.
•
Do not let children play with the machine. Dress properly. Do not wear loose clothing or jewellery. They can
•
be caught in moving parts. Wear protective hair covering to contain long hair.
Use safety glasses, a dust mask and protection gloves. Also use ear protection if the noise level exceeds 85
•
dB(A).
Do not overreach. Keep proper footing and balance at all times.
•
Check for damaged parts. Never use a damaged machine. Damaged parts must be properly repaired or
•
replaced by an authorized service centre.
• Avoid unintentional starting. Always disconnect tools when they are not in use. Also before servicing,
changing accessories, ...
Always use a suitable cable according to the specifications of this machine.
•
Always keep the area of the power supply socket free when operating the machine. You must always be
•
able to disconnect the machine immediately when necessary.
• Never unplug the machine by pulling the cable.
• Never unplug the supply cord when the machine is operating.
Do not force the machine. It will do a better job and operate more safely at the rate for which it was
•
intended.
Maintain tools with care. Keep tools clean for better and safer performance.
•
Consider work area environment. Do not use electric tools in damp or wet locations. Keep the work area
•
well lit. Do not use electric tools near flammable liquids or gases.
Never point the machine to yourself, other persons or animals.
•
Before using the machine you must check the connections and air supply. Make sure that the hoses are
•
protected from kinks. A damaged hose must be replaced immediately. Make sure the hose clamps are
tightened well.
• Avoid unintentional starting of the machine. Make sure the machine is switched off before connection/
disconnecting hoses or when carrying the appliance.
Use a detector to determine if electric, gas, water lines and more are hidden in the work area.
•
When you notice a problem you must switch off the machine and disconnect the air supply.
•
Be careful when removing a stuck nail. Make sure the machine is switched off and the air supply
•
disconnected.
• Avoid water in the air filter and air compressor. If you notice water in it you must switch off the machine
and disconnect the air supply. If not you could damage the machine.
When you are not using the machine you must disconnect the air supply and empty the nail/staple
•
magazine.
3. Overview
Refer to the illustrations on page 2 of this manual.
4. Operation
• Place the nose of the machine on the preferred position of the workplace.
V. 02 – 14/04/2015
TM91001

USER MANUAL

2 ©Velleman nv