Festool HKC 55 EB Guide D'utilisation page 15

5
5-7
5-8
5-9
5-10
5-11
Swivel saw to 0° position before replacing the

saw blade and set maximum cutting depth.
Position saw on motor cover when replacing[5-

1].
Turn lever [5-4] as far as stop.

Open the screw [5-8] using the Allen key[5-3].

Hold the pendulum guard open [5-7] only with

retractor lever [5-5].
Remove saw blade[5-9].

Insert new saw blade.

The direction of rotation of the saw blade
[5-10] and saw [5-6] must match.
Insert the outer flange [5-11] so that the pin en-

gages in the recess on the inner flange.
Release retractor lever [5-5] and allow the pen-

dulum guard to swivel back [5-7] to its final po-
sition.
Tighten screw [5-8].

Reposition lever [5-4].

5-1
5-2
5-3
5-4
5-5
5-6
Dust extraction
WARNING
Dust hazard
Dust can be hazardous to health. Always work

with a dust extractor.
Always read applicable national regulations be-

fore extracting hazardous dust.
Independent extraction
Secure the connection piece [6-2] of the dust

collection bag [6-3] at the extractor connector
with a clockwise rotation [6-1].
To empty remove the connection piece [6-2]of

the dust collection bag [6-3] from the extractor
connector with an anti-clockwise rotation [6-1].
Festool mobile dust extractor
A Festool mobile dust extractor with an extractor
hose diameter of 1-1/16" (27 mm) or 1-7/16"
(36 mm) (36 mm is recommended due to the re-
duced risk of clogging) is connected to the extractor
connector at the elbow [1-10].
– Static charge may occur if an anti-static suction
hose is not used. The user may suffer an electric
shock.
6
6-1
6-2
6-3
15