Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
All operating elements and connections de -
scribed can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 LC display to indicate the group (
channel and the battery status in 4 levels
2 On / off switch
3 Microphone input (4-pole mini XLR)
4 Button SET
to activate the setting modes one after another
group (keep button pressed for a while)
→ channel → sensitivity → transmission
power → automatic frequency matching
→ identification number → lock function
and to confirm the settings
Note: When the lock function has been activated [indi-
cation
when you press a button or use the switch
(2)], you will only be able to activate the setting mode
for the lock function (
5 Button – to make settings in the different setting
modes (to search in descending order, to select
a lower value and to deactivate functions)
6 Button + to make settings in the different setting
modes (to search in ascending order, to select a
higher value and to activate functions)
7 Buttons to unlock the battery compartment
cover (8): press the buttons firmly and fold up
the cover
8 Battery compartment cover
9 on the rear: Rotary switch to attenuate the level
(6 dB or 20 dB), adjustable with the small screw-
driver provided
2 Important Notes
This unit corresponds to all relevant directives of
the EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity and heat (admissible ambient tempera-
ture range: 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
8
...
chapter 5.1.6).
.
correctly operated, or if it is not repaired in an
expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.
, the
)
3 Applications
The UHF PLL pocket transmitter IN-264TB / 2 is
designed for transmission in the frequency range
740 – 776 MHz. It is suitable for operation with the
following receivers from JTS:
– IN-164R/2 with one receiver unit
– IN-264R/2 with two receiver units
The pocket transmitter is supplied with the lavalier
microphone CM-501. Instead of the CM-501, it will
also be possible to use other microphones from the
JTS product range which are designed for opera-
tion with a pocket transmitter and equipped with a
4-pole mini XLR connection, e. g. the headband
microphone CM-204U or the instrument micro-
phone CX-516W.
The transmitter with the microphone connected
and the receiver create a wireless audio transmis-
sion system. The transmission channel is selected
from 6 channel groups of different size; the largest
group contains 22 preset channels. The transmis-
sion range depends on local conditions; in free field
it may reach a maximum of 300 m.
The REMOSET function of the system will auto-
matically match the frequency between the trans-
mitter and the receiver unit.
3.1 Conformity and approval
Herewith, MONACOR INTERNATIONAL declare
that the unit IN-264TB/2 is in accordance with
the basic requirements and the other relevant reg-
ulations of the directive 1999 / 5 / EC. The decla -
ration of conformity is available on the Internet
(www.jts-germany.de or www.monacor.com).
This unit may be operated in the following coun-
tries:
DE
In the Federal Republic of Germany, the transmitter
IN-264TB/2 requires a frequency assignment (for
which a charge is payable).
In other countries, it is necessary to apply for a cor-
responding approval. Prior to operating the system
outside Germany, please contact the MONACOR
subsidiary or the corresponding authorities of the
Publicité
Table des Matières
