OEG e-Peilstab plus Manuel D'utilisation page 7

2. Choice of tank height in cm (not possible with tank type "Spherical")
A three-digit display appears: "000cm".
Short pressing: Number increases continuously.
Long pressing: Number is saved (vibration).
Display jumps into litre indication after the last digit.
3. Choice of capacity in litres
A five-digit display with point appears: "00.000".
Short pressing: Number increases continously.
Long pressing: Number is saved (vibration).
The first measurement is taken.
The display changes automatically between litres (L), percent (%) and centimetres (cm).
The results of the measurements are not suitable for billing purposes.
Operation
• Press the square to start the measurement.
• After a short time, the filling level is indicated in cm, l and %.
• Perform a second measurement as a control check. If different results are indicated, perform further measurement,
until the measuring values are stable.
• When the indicator flashes, change the battery.
Note:
The suction pipe of your heating system may end up to 20 cm above the tank bottom.
The heating oil below is not available for heating purposes.
Battery change
1. Pull e-Dipstick plus off rear plate.
2. Change battery at the clip. Battery type: 9 V monobloc alkaline
3. Place e-Dipstick plus onto the rear plate and push into the clamp.
Technical data
Measuring principle:
Max. filling level:
Tolerance:
Power supply:
Protection class:
Ambient temperature:
Connection hose:
External dimensions (without hose):
e-Dipstick plus
hydrostatic pressure
300 cm fuel oil column
± 1 cm
9 V monobloc battery
IP20
0 up to +35 °C
1 m
68 mm × 97 mm × 22 mm (W x H x D)
7
GB