Product Installation - Aqara Hub G3 CH-H03 Manuel D'utilisation

* It prompts that "No accessories are found". Please reset the camera, wait
for 3 minutes, and then manually enter the HomeKit setting code to add it
again.
Add accessory
4
A er the camera is added successfully, please open the Aqara
Home app and refer to the operation manual of the accessory
to add.

Product Installation

1 The packaging box of this product does not contain a
bracket, but does support a 1/4-inch threaded screw. If wall
mounting or li ing is required, the bracket or any other
threaded screw-compatible mount shall be purchased
separately.
2
Please ensure that the camera is successfully added to the
app before mounting it on the wall.
The camera can be placed on a writing desk, dining room
3
table, bookcase, co ee table or other horizontal surfaces for
use.
4 A er mounting the camera in the li ing position, the image
needs to be flipped in the Aqara Home app to be viewed
normally.
* The camera should be placed within the range of wireless Wi-Fi signal
coverage.
* Do not place it near a strong electromagnetic interference source.
* Avoid a direct light source to camera lens at close range.
* Make sure there are no obstructions around the device.
* This product is only for indoor use.
5