Display Error Messages; Advanced Mode; Time Settings; Sleep Mode - Topcom 201 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

EAR & FOREHEAD THERMOMETER 201

8.5 DISPLAY ERROR MESSAGES

'HI'
The measured temperature is > 42,9 °C / 109,3 °F.
'LO'
The measured temperature is < 32,0 °C / 89,6 °F
'ErrE'
The ambient temperature is not within the operation
'ErrU'
specifications.
Does not measure after pressing 'Measure'. Follow the steps
'ErrH'
mentioned in the user guide.
An error is detected during self-check. Remove the batteries for
'ErrS'
10 seconds and try again.
'ErrR'
Sensor error. Do not use the thermometer under extreme
'ErrL'
environment.
'ErrP'
Hardware problem. Return the unit to the service center.
Battery low. Replace the battery.
Hardware problem. Return the unit to the service center.
9

ADVANCED MODE

9.1 TIME SETTINGS

• Power on the unit by pressing the START - button
hear a short beep. Time mode is displayed.
• Press and hold the SET - button
ing.
• Press the SET - button
• Press the OK - button
• Press the SET - button
• Press the OK - button
• Repeat previous steps for setting the minutes, year, month and day.
• After setting the day, the unit will enter sleep mode setting.

9.2 SLEEP MODE

When sleep mode is not activated, the display is continuously ON.
The display will toggle between time and room temperature.
After setting the hour, sleep mode setting is displayed:
• Press the SET - button
• Press the OK - button
8
. The 24hr/12hr system is blink-
7
to switch between 24hr and 12hr system.
7
to confirm. The hour digits are blinking.
8
repeatedly to increase the digit.
7
to confirm. The minutes digits are blinking.
8
to switch between ON or OFF.
7
to confirm.
8
once. You will

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Hv-t68

Table des Matières