Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
opEraTion
opEraTion CKT 15 E / CKT 20 E
5.
Operation CKt 15 e / CKt 20 e
1
2
1 Temperature selector
2 Timer
5.1
starting heating
The temperature is infinitely adjustable. The appliance
stops heating as soon as the selected room temperature
has been reached.
fTurn the temperature selector clockwise to the re-
quired setting.
5.2
adjusting the time switch
With the time switch, the appliance heats with full output
and without temperature control.
fTurn the Timer clockwise to set any number of min-
utes to count down from 0 - 60 minutes.
5.3
stopping heating / frost protection
This position ensures frost protection. The heater starts
automatically if the room temperature drops below the
frost protection temperature.
fTurn the temperature selector fully counter clockwise
and ensure that the time switch is set to "0".
www.sTiEbEl-ElTron-usa.Com
6.
Cleaning, care and maintenance
The appliance contains no user serviceable parts.
Clean the appliance when cold with ordinary cleaning
products. Avoid abrasive or corrosive cleaning products.
If a pale brownish discoloration appears on the appliance
casing, wipe this off as soon as possible with a damp
cloth.
Damage to the appliance and the environment
!
Never spray cleaning spray into the air slot.
7.
storage
fWhen not in use, keep the appliance in a dry place.
8.
troubleshooting
If the appliance does not heat, check the temperature set
at the appliance and the circuit breacker.
The appliance has a safety high limit that shuts the ap-
pliance down if it overheats. After the cause has been re-
moved (for example air outlet or inlet apertures covered)
and the appliance has cooled down for a few minutes,
operation starts again.
If you cannot remedy the fault, notify the contractor who
installed the appliance. To facilitate and speed up your
enquiry, please provide the serial number from the type
plate (000000-0000-000000).
| CK 15-20 E / CKT 15-2 E|
5
Publicité
Chapitres
Table des Matières
