Connection To Power Supply - KRONAsteel Inga S Guide De L'utilisateur

EN Application sheet
7. Make a marking for fixing the lath of the inner
decorative casing (Fig. 13).
8. Drill 2 holes with the diameter of the attached
dowels.
9. Install 2 anchors in the drilled holes and
tighten the bar to fix the decorative cover.
10. Attach the bar of the inner decorative duct to
the required height, similar to the outer cover
of case.
11. Before installing decorative cases, connect
the hood to the mains.
12. Place the inside of the casing in the outer
casing. Install the outer case on the hood.
13. Lift the inner part of the casing up to align
the casing attachment points and the casing
attachment plate and connect them. (Fig. 14).
KITCHEN HOODS

CONNECTION TO POWER SUPPLY

The kitchen hood is connected to the power net-
work with the voltage of 220-240V, 50 Hz.
The kitchen hood should be connected to a wall
outlet with earthing to avoid electrocution.
It is absolutely prohibited to cut off the plug
during kitchen hood installation.
The damaged electrical cord should be re-
placed by a qualified service specialist.
For additional protection of the kitchen hood from
voltage drops in the network, connect it though an
additional automatic switch 6A.
The kitchen hood is installed.
Switch it on and use it as you please.
13