KRONAsteel Inga S Guide De L'utilisateur page 11

EN Application sheet
INSTRUCTIONS ON THE USE OF
THE KITCHEN HOOD
The kitchen hood is to be used for extraction of
smells from the kitchen. It may work in two modes
depending on the method of its installation:
— mode of air removal into the air shaft;
— recirculation mode.
In the mode of air removal into the air shaft (see
Fig. 4), the kitchen hood is connected to the air
shaft with the help of a corrugated hose or a plas-
tic air conduit. Thus, all the evaporations from the
kitchen, smells, char and soot pas through reus-
able aluminum grease trap filters and are removed
outside the premises. With this working mode, it is
not necessary to install charcoal acrylic scent-trap
filters. Extraction mode is the most efficient as the
kitchen hood removes all the evaporations from
the kitchen to the air shaft.
In the recirculation mode (see Fig. 5), the kitchen
hood is not connected to the air shaft, and thus the
air is just passed through the kitchen hood inside
the kitchen.
In this mode, charcoal acrylic disposable scent-
trap filters should be installed on the kitchen hood.
These filters are not included in the set and are
bought separately. The use of the kitchen hood in
the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the
mode of air extraction to the air shaft.
KITCHEN HOODS
KITCHEN HOOD MAINTENANCE
Disconnect the power supply before you
start any operation related to cleaning or re-
pair of the kitchen hood.
To clean the painted exterior of the kitchen hood,
use a piece of cloth wet with warm water and a neu-
tral cleaning agent. To clean exterior surfaces made
of steel, copper and brass, use special agents and
follow corresponding instrucitons. Never use chlo-
rine- or acid-containing agents, abrasive materials
or sponges that may scratch the surface.
The alu grease filter clogs up with grease particles
and penetrating air dust. To clean it, do not use
acid-containing agents; wash it upon preliminary
soaking in hot water, using an effective cleaning
agent or, if possible, use a dish-washing machine
(at a temperature of 65 °C).
Do not wash heavily polluted grease filters with
dishes. The grease filter cleaning should be simul-
taneously done with removal of grease deposits on
any accessible elements of the kitchen hood body.
The alu filter removal is shown in Figure 6. To re-
move the filter, first open the hinged panel, lift the
spring lock handle, pull it to remove the filter.
Mount the filter after it has completely dried out.
The filter shall be mounted in the reversed order.
Press and spring lock on the filter, mount it in its
position and release the spring lock.
Coal filters are mounted upon protecting grids of
the kitchen hood motor case that is beneath the
grease filter. To mount the filter, slightly push that
against the grid of the motor case and turn it clock-
wise, until it is engaged on the grid (Fig. 7). To re-
move the filter, slightly push that against the grid
and turn it counterclockwise until it is disengaged.
Replacing the backlight lamps
To replace the backlight lamp (Fig.9), it is necessary
to:
Mounting coal filters
11