Connecting The Gas Supply - Hatco KRAMPOUZ KGRDG Série Manuel D'installation Et D'utilisation

English
NOTICE
Allow adequate ventilation around base of unit for proper
air supply to gas burner.
Do not locate unit in an area subject to excessive
temperatures or grease from grills, fryers, etc. Excessive
temperatures and grease could cause damage to unit.
Damage to any countertop material caused by heat
generated from this equipment is not covered under the
Hatco warranty. Contact manufacturer of countertop
material for application information.
6. Place the unit in the desired location.
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
7. Make sure the drip tray is installed on the front edge of
the unit. Make sure the peg on each tray handle is seated
securely in the notches on the griddle frame.
Installing the Drip Tray
8. Contact an authorized gas equipment installer to connect
the gas supply line to the unit. Review "Connecting the Gas
Supply" in this section with the installer.
Form No. KGRDGM-0120
Notch
Peg
Drip Tray
Tray Handle

Connecting the Gas Supply

Gas Griddles must be connected to an approved gas supply
line by an authorized and certified gas equipment installer.
Understanding the following information is required for proper
and safe installation.
• Verify that the unit is configured properly for the gas
supply—natural gas or propane. The specification label
indicating the gas configuration of the unit is located on the
back of the unit.
• Install the unit in a location with sufficient ventilation to
prevent the buildup of unsafe levels of noxious fumes.
• Make sure there is proper air flow around the unit for
combustion air. Do not obstruct the air ventilation openings
around the griddle or frame of the unit.
• Connect the unit to the gas supply piping using a moveable
gas connector that complies with ANSI Z21.69 / CSA 6.16
and a quick-disconnect device that complies with ANSI
Z21.41 / CSA 6.9.
• Make sure unit is installed with the included pressure
regulator and gas shut-off valve.
Pressure
Regulator
3/8" NPT Fitting
Rear View, Gas Connection
IMPORTANT NOTE
After shutting down a Gas Griddle, a five minute waiting
period is required before relighting. This allows potential gas
buildup to clear.
7
INSTALLATION