Technical Information; Technical Data; Safety Devices - Nussbaum ATT COMBI LIFT CL 4.40 S Manuel D'exploitation

• To start the emergency discharge push the cen-
tre of valve V2 (16) with a sharp object. The lo-
wering process starts immediately.
• Always observe the lowering process.
• If there is a hazard, release valve V2 (16).
• Lower the lift to the lowest possible position.
During the emergency discharge ensu-
re there are no people under the lift!
• If required, firstly inform customer service.
• Only operate the lift if it is in seamless condition
from a safety point of view.
8

Technical information

8.1

Technical data

System load capacity
without wheel jack
with wheel jack (optional)
Load distribution
against the drive- in direction
Effective lifting range
of the system
System lift time
System lowering time
Motor capacity
Motor speed
Hydraulic pump
Operating pressure with load
Pressure relief valve
Filling volume oil
container
Noise level
Operating voltage
On-site connection
according to VDE regulations
58 COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
4,500 kg
4,000 kg
Max. 2:1 or 1:2 or
Approx. 1,826 mm
<25s with 3,000 kg load
<30s with 3,000 kg load
3 kW
2,880 rpm
2.7 cm³/s
Approx. 250 bars
Approx. 290 bars
Approx. 13 litres (HLP32)
≤ 70 dB(A)
3 x 400 V, 50 Hz
3~/N+PE, 400 V, 50 Hz
with 16 A fuses, slow,
8.2

Safety devices

• Deadman controls
Lift movement stops when a button is released.
• Reversing switch with curtain lock device
Fuse to prevent unauthorized use.
• Over-pressure valve
Hydraulic system fuse against over-pressure.
• Check valve
Secure the vehicle against unauthorized lowe-
ring.
• Safety catch
Secure against unauthorized lowering of the lift.
• CE-Stop
Acoustic warning signal when lowering below
200 mm above the floor.
Secure against crushing in the foot area when
nearing the floor.
• Roll back and roll over safety at the ends of the
drive-in rails
Secure against falling vehicles in the raised con-
dition.
25.09.2015 20110006 OPI