Positioning The Vehicle; Platform Illumination (Optional); Lifting The Vehicle; Set Down Into The Safety Ratchets - Nussbaum ATT COMBI LIFT CL 4.40 S Manuel D'exploitation

5.2

Positioning the vehicle

• The lift must be completely lowered before the
vehicle is driven on, and it may only be done in
the intended direction.
• Drive the vehicle over the drive rails lengthwise
and cross-wise in the centre.
Drive in the middle of the lift.
• For vehicles with low floor clearance or custom
equipment, check whether it could be dama-
ged before driving onto the lift.
! The entire contact area of each wheel must be
completely on the drive-in rails, otherwise the-
re is a danger of falling!
• Secure the vehicle against rolling, pull the hand
brake, engage the gears.
5.3

Platform illumination (optional)

There are four lamps integrated on the interior side
of the drive rails to give equal illumination of the
work area.
The illumination is switched on via the main switch
(7) of the platform.
5.4

Lifting the vehicle

• During the entire lifting or lowering process, the
work area of the lift should be clear of people
and objects.
• Afterwards, lift the vehicle to the desired working
height.
Absolutely ensure
placement on the drive-in rails, other-
wise there is a danger of the vehicle fal-
ling.
52 COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
Drive-in direction
secure vehicle
• Switch on controls at the main switch (7).
• Lift the vehicle. Push the o "LIFT" (8) button.
• Raise the vehicle to the desired working height.
• The entire lifting process must be continuously
observed.
5.5

Set down into the safety ratchets

• Pushing the "Lower into catches" button u (10)
sets the lift down into the next possible catches.
• Keep the "Lower into catches" button u (10) until
all four safety ratchets (14) are latched in and
the lift can no longer move downwards.
Before working on the vehicle always
lower the lift into the safety ratchets.
007
5.6

Lift out of the safety ratchets

Check the hazardous area around the
platform and ensure that there are no
people or objects in the immediate vi-
cinity of, or on, the platform.
• Push the o "LIFT" (8) button until the catches are
released.
5.7

Lowering the vehicle

! Check that there are no people or objects in
the hazardous area of the lift.
• Push the "LOWER" button u (9) to start the lowe-
ring process.
• The lift moves approx. 10 cm upwards to release
the 4 safety ratchets which are then electrically
retracted.
• Lower the lift to the desired position.
• The entire lowering process must be continuously
observed.
• Shortly before reaching the lowest position the
lift automatically switches off to prevent crushing
in the foot area (CE stop).
25.09.2015 20110006 OPI