Nussbaum ATT COMBI LIFT CL 4.40 S Manuel D'exploitation page 4

ENGLISH
Contents
1 Introduction _____________________________ 45
2 General information _____________________ 46
2.1 Set up and test the system. ___________________ 46
2.2 Hazard information __________________________ 46
3 Safety regulations _______________________ 46
3.1 Safety inspection ____________________________ 47
4 Assembly and commissioning ____________ 47
4.1 Set up guidelines ____________________________ 47
4.2 Commissioning ______________________________ 48
4.3 Changing the assembly location _____________ 48
4.4 Selecting the anchors ________________________ 48
4.5 Assembly ____________________________________ 49
4.6 Set up and anchoring the lift _________________ 49
4.7 Electrical connections _______________________ 50
4.8 Loose / broken cable switch __________________ 50
4.9 Commissioning the platform __________________ 50
4.10 Adjusting the drive-in rails ____________________ 51
5 Operating manual _______________________ 51
5.1 Operating element __________________________ 51
5.2 Positioning the vehicle _______________________ 52
5.3 Platform illumination (optional) _______________ 52
5.4 Lifting the vehicle ____________________________ 52
5.5 Set down into the safety ratchets _____________ 52
5.6 Lift out of the safety ratchets _________________ 52
5.7 Lowering the vehicle _________________________ 52
5.8 Safety switch below the drive rails ____________ 53
6 Maintenance and care of the system _____ 53
6.1 System maintenance plan ___________________ 53
6.1.1 Daily, as required or visible damage __________ 53
6.1.2 Maintenance 1 x per year ____________________ 53
6.1.3 Maintenance every 2 years __________________ 55
6.1.4 Maintenance every 6 years __________________ 55
6.2 Cleaning and care of the system _____________ 55
7 Behavior in cases of error ________________ 56
7.1 Moving onto an obstacle ____________________ 57
7.2 Lift emergency discharge ____________________ 57
8 Technical information ____________________ 58
8.1 Technical data ______________________________ 58
8.2 Safety devices _______________________________ 58
9 System master sheet _____________________ 59
9.1 Manufacturer ________________________________ 59
9.2 Purpose _____________________________________ 59
9.3 Changes to the design / construction _________ 59
9.4 Changing the assembly location _____________ 59
4 COMBI LIFT 4.40 S-S A-S PLUS-S PLUS AMS - HYMAX II 4000 S-S A-S PLUS-S PLUS AMS
Page
10 Data sheets _____________________________ 60
10.1 COMBI LIFT 4.40 S - HYMAX II 4000 S ___________ 60
10.2 COMBI LIFT 4.40 SA - HYMAX II 4000 S A ________ 61
10.3 Foundation plan _____________________________ 62
11 Hydraulic plan __________________________ 63
12 Replacement parts list ___________________ 64
13 Set up protocol __________________________ 75
13.1 Transfer protocol _____________________________ 76
14 Single safety inspection before commissio-
ning ____________________________________ 77
14.1 Regular safety inspection and maintenance __ 78
14.2 Exceptional safety inspection ________________ 79
15 Electrical circuit diagram _______________ 189
15.1 3 x 230 V ___________________________________ 189
15.2 3 x 400 V ___________________________________ 193
16 Declaration of conformity _______________ 197
25.09.2015 20110006 OPI