Venta COMFORT PLUS LW15 Mode D'emploi page 14

1
3
5
1
3
4
2
26 EN
2
4
2
1
3
4
6
5
6
3
2
1
4
CLEANING THE UPPER
HOUSING OF THE DEVICE
Attention! Ensure that the device is switched off during any measures
!
and the switching power supply is disconnected from the outlet!
01 Detach upper housing from lower housing. Press locking buttons so
that the ends stand up.
02 Fold side parts out of the way.
03 Fold ribbed wings out of the way.
04 Pull the plug of the switching power supply out of the drive unit
drive unit upwards and out . Disconnect the cable from the switching
2
power supply from the holding bracket
ning of the upper housing downward and out
· Do not disassemble the drive unit and switching power
!
supply, do not submerge into the water and do not bring
in contact with liquid!
∙
Only clean the drive unit with fan blades and gear with
a dry cloth!
∙
The disassembled upper housing can be cleaned under
running water!
∙
The disassembled upper housing must be absolute dry
before assembly!
05 Place drive unit in upper housing and ensure that it is laterally correct
Pull plug of switching power supply from bottom through opening of
the upper housing upwards and plug into drive unit up to the limit
2
Fasten cable in holding bracket
06 The outer ends of the locking buttons must be standing up. Fold ribbed
wings and upwards, and finally the side parts
1 2
upper housing properly again by pushing on the outer ends of locking
buttons and .
5 6
. Pull
1
and pull out through the ope-
3
.
4
1
.
3
.
4
and . Close
3 4
EN
.
27