Connecting The Suction Device; Connecting The Suction Tube - Dentsply Sirona inLab MC X5 Notice D'utilisation

Dentsply Sirona
Operating Instructions Suction devices for inLab MC X5 and
64 98 609 D3608
D3608.201.02.04.02 09.2017
4.4

Connecting the suction device

4.4.1

Connecting the suction tube

1. Connect one end of the suction tube to the available connection point
on the suction device. The connection point is located on the top side
next to the control panel with the suction power controller.
2. Connect the other end of the tube to the socket (A) on the rear side
A
of the inLab MC X5 processing machine.
or
Connect the other end of the tube to the rear side of the CEREC
➢
MC/MC X/MC XL Premium Package milling and grinding unit.
Notes on the suction tube:
The suction tube is supplied at a length of approx. 2.40 m (inLab MC X5)
or 2.0 m (CEREC MC/MC X/MC XL Premium Package). When
connecting the suction device to the unit, please ensure that no sharp
bends occur over the full length of the suction tube.
Reduce the length of the tube according to your requirements and your
installation location. Note that suction power drops along the length of the
tube. You obtain decent suction power if the suction device is placed
immediately below the machine and you have a tube length of 1.2 m or
less.
4 Transportation and installation
15