Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
device which will switch off it in case
of accidental overheating. To reset,
please contact Customer Experience,
see enclosed guarantee.
SAVE THESE
INSTRUCTIONS
THIS PRODUCT IS FOR HOUSEHOLD USE
ONLY
DESCRIPTION
A
display
B
on-standby button
C
increase button
D
decrease button
E
power button
F
ECO button
G
timer button
H
cord holder
I
wheel
USE
Fitting the wheels
Turn the radiator upside down on a rug or soft surface to
prevent damaging the paint finish. Fully unfold the wheels
by turning them outwards (Fig. 1). Turn the radiator back to
its upright position.
Fig. 1
Important! Always operate the appliance in upright
position only (wheels on the bottom, controls on top). Any
other position could create hazardous situation
Location
Place appliance on the floor beneath the coldest window
in the room, or any other location. Your appliance will re-
duce the effect of cold drafts. The appliance should not be
placed immediately below a power outlet. Do not use this
appliance in rooms with a floor area of less than 43 square
feet (4 sq. m.).
Power connection
-
Before using the appliance check that your supply volt-
age is the same of that shown on the rating label of the
unit and that the power socket and power supply line
correspond to the load specified.
-
Check also the current capacity of your fuses. CONNECT
YOUR HEATER TO EARTH PROVIDED SOCKET ONLY.
Plug in the heater, the appliance will be set in the stand-by
condition. The display will show the
clothing or bedding, furniture and flammable material away
from the power outlet where the heater is plugged in. After
an interruption of the power supply (power failure or appli-
ance unplugged) the unit always goes to stand-by.
Heating function
To turn the appliance on, insert the plug into an electrical
outlet then press the
Press button
(E) to set the required power level:
MIN (
); MED (
select the desired temperature, press button + or - (C or D).
By pushing the + or - button once, the temperature (shown
on the display) will increase or decrease by 1°C. Keeping the
+ or - button depressed the value will increase or decrease.
The appliance allows you to set the temperature from 5°C
(41°F) to 28°C (82°F).
Anti-freeze function
Setting the temperature to 5°C (41°F) with the "-" button, the
appliance will activate the Anti-freeze function.
The display will show the
ance will turn on automatically, at the max power, only if the
room temperature falls below 5°C (41°F). If you wish to go
back to the heating function, press the "+" button once. After
an interruption of the power supply (probe failure or appli-
ance unplugged) the unit goes always to stand-by.
ECO function
When this function is active the appliance automatically sets
the most appropriate power level to guarantee optimum
comfort while reducing energy consumption.
To activate this function press the "ECO" (F) button. The dis-
12
symbol. Keep loose
(B) button.
); MAX (
) (see fig. 2). To
Fig. 2
symbol, in this way the appli-
Publicité
Table des Matières
