Installation - Muskoka LEGION EST-425T-10 Guide D'utilisation Et D'entretien

Installation

The stove should be located in an area:
1. Out of direct sunlight
2. Not susceptible to moisture
3. Away from uninsulated outside wall
WARNING
The stove is heavy and should be
assembled near its desired location.
It is recommended that two people move
the assembled stove to prevent injury.
WARNING
Do not install the unit on shelves, raised platforms, beds, blankets, pillows etc. Keep combustible
materials such as furniture, bedding, papers, clothes and curtains at least 3 ft. (914 mm) from the stove.
ASSEMBLY INSTRUCTIONS
1. Lay the stove (A) upside down on a padded surface with the underside accessible. Attach the leg (B) to
the stove by inserting the tab on the top of each leg (B) into the corresponding slot on the bottom of the
stove (A). Insert two screws (C) into predrilled holes and tighten securely for each leg (B).
2. Carefully position the stove against a wall.
3. Plug the power cord into the 15-amp, 120-volt outlet. Use an extension cord rated for a minimum of 1,875
watts if necessary.
CAUTION: Make sure that the unit is installed so that the power cord is not compressed against or caught on the stove and
that it has an unobstructed path to the grounded outlet.
8
Clearance to Combustibles
Sides 4 in. (101.6 mm)
Floor 0 in. (0 mm)
Top 36 in. (914 mm)
Front 36 in. (914 mm)
Rear 0 in. (0 mm)