Electrical Connection; Grounding Instructions - Muskoka LEGION EST-425T-10 Guide D'utilisation Et D'entretien

Safety Information (continued)

ELECTRICAL CONNECTION

A 15-Amp, 120-Volt, 60 Hz circuit with a properly grounded outlet is required. Preferably, the
item will be on a dedicated circuit as other appliances on the same circuit may cause the
circuit breaker to trip or the fuse to blow when the heater is in operation. The unit comes stan-
dard with a 6 ft. (1.8 m) long three wire cord, exiting the right side of the item. Always plug the
unit into a wall outlet/receptacle. An extension cord or re-locatable power tap, (outlet/power
strip), should never be used.
Electrical outlet wiring must comply with local building codes and other
applicable regulations to reduce the risk of fire, electrical shock and injury
to persons.
Do not use this item if any part of it has been under water. Immediately
call a qualified service technician to inspect the item and replace any part
of the electrical system which has been under water.

GROUNDING INSTRUCTIONS

This heater is for use on 120 volts. The cord has a plug as shown at (A) in Figure 1. An adapter as shown at (C) is
available for connecting three-blade grounding-type plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such as a properly grounded outlet
box. The adapter should not be used if a three-slot grounded receptacle is available.
(A)
GROUNDING
PIN
ADAPTER
GROUNDING
MEANS
(C)
4
DANGER
Figure 1
METAL SCREW
COVER OF GROUNDED
OUTLET BOX
(B)
GROUNDING
PIN
NOTE: Adapters are NOT
for use in Canada.
(D)