Electrical Safety; Start-Up - ULTIMATE SPEED UMK 10 B2 Instructions D'utilisation Et Consignes De Sécurité

General Safety Information / Start-up
- for cleaning or maintenance;
- if the power cable is damaged;
- if foreign objects enter the device or you notice
unusual noise.
Only use accessories supplied and recom-
mended by the manufacturer.
Do not attempt to repair the device yourself.
CAUTION:
How to avoid accidents and
injuries from electric shock:

Electrical safety:

Do not use the device if the switch cannot be
switched on and off. Have a defective switch
replaced.
Do not carry the device by the cable. Do not
unplug from the socket by the cable. Protect the
cable from heat, oil and sharp edges.
Only connect the connection cable to the ciga-
rette lighter socket in the car.
Follow the instructions of your automaker on
using the cigarette lighter socket.
If the cable is damaged, immediately unplug from
the cigarette lighter socket.
The connection cable on this device cannot be
replaced. Dispose of the device if the cable is
damaged.

Start-up

Place the device on a level, non-flam-
mable surface. Never cover the vents.
Do not operate the device in dusty
environments. Doing so poses a fire
hazard and could damage the device.
For inflatables with counterpressure (e.g. partly
filled car tyre): Switch on the device before con-
necting the car valve
Note: Depending on the inflatable you can use the
connection valve directly or along with the included
7
valve adapters (see Fig. A).
10
32 GB
113044_uls_Mini-Kompressor UMK 10 B2_Content_DE_AT_CH.indd 32
to the tyre.
7
Connecting to the cigarette lighter socket:
Note: Verify the socket of the cigarette lighter in your
vehicle has an adequately sized fuse.
Verify the device is switched off: on / off switch
to position "0".
Plug the cigarette lighter plug
of the 12 V cigarette lighter.
Connecting the connection valve
Open the connection valve
lever vertical (Position 1, see Fig. B).
8
Connecting without valve adapter
- Insert the open connection valve
valve of the inflatable (if necessary, first re-
move valve cover of the inflatable).
- Hold the connection valve and close: push
tensioning lever toward connection valve
8
(position 2, see Fig. C).
Connecting with valve adapter
- Push the respective valve adapter into the open-
ing in the connection valve
- Secure the valve adapter into the connection
valve : push tensioning lever
7
connection valve (Position 2).
- Insert the valve adapter into the valve on the
inflatable (if necessary, first remove valve cover
of the inflatable).
Switching on / off:
Switch the device on: on / off switch
position "I".
Once the desired filling pressure has been
reached, switch the device off: on / off switch
to position "0".
Remove the cigarette lighter plug
Removing the connetion valve:
Connecting without valve adapter
the tensioning lever
8
and remove from the valve of the inflatable.
7
Connecting with valve adapter
Remove the valve adapter from the valve of the
inflatable. Open the tensioning lever
connection valve and remove the valve
7
adapter.
6
into the socket
5
:
7
: tensioning
7
:
10
into the
7
:
10
.
7
toward
8
to
6
6
.
5
: Open
10
for the connection lever
:
10
of the
8
11.06.15 16:55