Attachment - Bosch DIB096850 Mode D'emploi Et Notice De Montage

Installing the lower support frame
Attach upper and lower parts of the
support frame at the specified total height
with 10 screws (preferred hole selection, see
diagram).
Ensure that the lower support frame is in
the correct position. The open side must be
facing the hob control.
NOTE: The support frame can be aligned
subsequently by loosening the fastening
screws on the ceiling.
Installing the extractor hood
1. Hook the extractor hood from below into
2. Attach the extractor hood to the support
Exhaust-air
mode
700-880
Circulating-air
mode
700-1000
3. Hook in retaining clip and screw tight.
4. Connect the pipes.
5. Connect the power supply.
the support frame.
Do not trap the power cord!
frame with 2 securing screws.
Installation
31