Operation Procedures; Installation Of Accessories - Kasanova BRO000003 Manuel D'instruction

HANDHELD STEAM CLEANER
14
Cleaning the floor boards
Install the extended connecting spray nozzle on the main body, then install bent spray
nozzle or round spray nozzle. Aim the spray nozzle at the floor board, and press down
the steam button to remove the dirt and stains in wall corners and on the floor.
OPERATING INSTRUCTIONS

Operation Procedures

1. Unpack the product, check the accessories and documents supplied with the product
and make sure that the product and accessories are not damaged.
2. Before use, please read the User Manual carefully. The steam cleaner is only for use
in households.
3. First, place the steam cleaner on a level platform, push down the safety cover, un-
screw the safety cap counterclockwise, and then install the funnel. As chatting:
(I) (II) .
4. Take suitable clean water with the measuring cup, and add the water into the tank.
(Max. capacity of the tank is 350ml. Do not overfill the tank and some space must be left
in the tank). Re-install the safety cap and tighten it in position
5. Check the power supply and socket, and confirm they comply with the requirements
given in the user manual, then connect the power supply.
6. Indicator lamp will turn off in 3 minutes after connect the power supply, it means steam
is ready. At this time put forward the safety switch on the steam button then lightly press
the steam button and check whether steam is sprayed out of the nozzle. (Do not aim the
spray nozzle at any animal, person or electrical products).
7. If there is steam sprayed out, release steam button and installs suitable accessories
according to your needs, then put forward the safety switch on the steam button, press
down the steam button,then pull back the safety switch, the steam button is fixed, the
unit will emit the steam continually in order to carry out the operations required by you.
8. When finish the cleaning job or stop the machine to do some other things, raise the
steam button, then safety switch will takes effort.

Installation of Accessories

1. Install the spray cup with hairbrush
Hold the pipe section of the spray cup with hairbrush in your hand, align the arrow on
the spray cup with the single-line mark on short spray nozzle on the machine body, and
insert the spray cup in position. Rotate the spray cup in clockwise direction, and align the
arrow on the spray cup with the double-line mark on short spray nozzle on the machine
body, as shown in Figure 1. Fix the spray cup on the machine body. To remove the spray
cup with hairbrush, please rotate the spray cup inversely (counterclockwise) as shown in
Figure 2, and align the arrow on the spray cup with the single-line mark on the machine
body. Then the spray cup with hairbrush can be pulled out.