Included Items; Technical Information; General Safety Advice For Electrical Power Tools - Parkside PMGS 12 B2 Instructions D'utilisation Et Consignes De Sécurité

Spigot nut
6
Spindle lock
7
Mains adapter (see Fig. A):
Plug-in device for plug
8
Tray
9
Mains adapter
10
Power cable (with mains plug)
11
Accessories (see Fig. B):
6 hSS drills
12
2 Mandrels for mounting tools
13
3 Polishing wheels
14
4 Grinding wheels
15
1 Metal brush
16
16 Cutting wheels
17
5 Collets
18
2 Plastic brushes
19
3 Milling bits
20
2 Engraving bits
21
5 Grinding bits
22
1 Combination tool
23

Included items

Q
1 Small drill
1 Mains adapter
1 Plastic case
1 Accessory kit (50-piece)
1 Operating instructions

technical information

Q
Small drill PMGS 12 B2:
Nominal voltage:
Nominal input:
Idle-running speed:
Max. drill bit diameter: ø 3.2 mm
Certified acc. to:
noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level:
Introduction / General safety advice for electrical power tools
4
12 V
22 W
n 5000–20000 min -1
0
EN60745-1; EN60745-2-1
EN60745-2-3
54.70 dB(A)
Sound power level:
Uncertainty K:
Evaluated acceleration, typical:
hand / arm vibration: 1.868 m / s
Uncertainty K = 1.5 m / s
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different
vibration levels and in many cases they may exceed
the values given in these instructions. It is easy to
underestimate the vibration load if the electrical pow-
er tool is used regularly in particular circumstances.
note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Mains adapter PMGS 12 B2-1:
InPUt:
Rated voltage: 230 V∼ 50 hz
oUtPUt:
Nominal voltage: 12 V
Nominal current: 1 A
Protection class: II /
Certified acc. to: EN61558
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
65.70 dB(A)
3 dB
2
2
GB 47