Putting Into Operation; Unpacking; Selecting The Scale Location; Leveling The Scale - Mettler Toledo ICS226 Mode D'emploi

30232252A ICS226

2 Putting into operation

2.1 Unpacking

1. Inspect the package immediately upon receipt.
– If the package is damaged, check for internal damage and file a freight claim with
the carrier, if necessary.
– If the package is undamaged, open the package.
2. Remove the scale from the package and place it on a solid, flat surface.
3. Check all parts with the checklist. Make sure no part is damaged or missing.
Keep the packing material and inserts, in case you need to return the scale to a METTLER
TOLEDO representative.

2.2 Selecting the scale location

The correct location is important for the accuracy of the weighing results.
➜ Select a stable, vibration-free and horizontal location for the scale.
➜ Observe the following environmental conditions:
– No direct sunlight
– No strong drafts
– No excessive temperature fluctuations

2.3 Leveling the scale

The scale should be precisely leveled horizontally to provide accurate weighing results.
1. Turn the levelling feet of the weighing platform until the air bubble is inside the inner
circle.
2. Tighten the lock nuts of the levelling feet.

2.4 Charging and discharging the battery

ICS226 provides a Ni-MH rechargeable battery as an option. When battery replacement is
required, contact the METTLER TOLEDO Service.
WARNING
Risk of explosion due to wrong operation of the battery or improper connection!
▲ Do not use the battery for any purpose other than those described in this manual.
▲ Do not disassemble, repair or otherwise manipulate the battery pack.
7
Putting into operation