Machine Set-Up - Clarke American Sanders 07164A Manuel De L'utilisateur

ENGLISH EN

MACHINE SET-UP

To prepare the machine for use follow this procedure:
1. Familiarize yourself with the machine. Read all danger, warning,
and caution statements and the Operator's and Parts Manual
before operating the machine. If you or the operator are unable to
read English, have this manual fully explained before attempting
to operate this machine.
2. Attach the handle to the base machine by following these
instructions:
a.) The handle label should be pointing towards the front of the
machine and the black iron casting should drop down into
the top of the base machine securely.
b.) Snap the three latches down to the base machine. The
hooks on the latches should slip over the keepers that are
attached to the base machine. The latches should require a
slight push to snap them into place (see fi gure 3).
c.) Plug the interconnect cord into the base machine (see
fi gure 3A).
3. Install or replace circular pads. The pad should be replaced if
they are ripped or torn or the hook material is too worn to allow
attachment of sandpaper. To install or replace the pad(s), follow
these instructions:
a.) Lock handle in the upright position.
b.) Tilt the machine back until it fully rests on the handle.
c.) While kneeling and facing the bottom of the machine,
remove the existing pad(s) and then center new pad(s)
over the grip face (see fi gure 4).
d.) Press the pad(s) against the grip face until the hooks in the
driver have set into the pad (see fi gure 4a).
e.) Return machine to the upright position.
CAUTION: Damage to the grip face on the driver pad will
occur if the machine is operated without a pad or
with a pad that is ripped or torn. Damage to the
grip face of the pad will occur if the machine is
operated without installing sandpaper.
WARNING: Never put yourself or let others be in a position to
get injured if the machine should tip or fall while
replacing the pad or changing abrasive.
-6-
®
American Sanders Operator's Manual (EN) - EZ Sand
Clarke
Figure 3
Figure 3A
Figure 4
Figure 4A