Waeco MyFridge MF-1F Mode D'emploi page 12

MF-1F.book Seite 12 Freitag, 3. März 2006 8:35 08
Operation
7 Operation
Before starting your new device for the first time, you should clean it inside and
outside with a damp cloth for hygienic reasons (please also refer to the see
"Cleaning and care" on page 13).
If the device malfunctions (e.g. due to electrostatic discharge) you only need to
press a function button for the device to function normally again.
7.1 Cooling drinks
➤
If you want to cool drinks, connect the device to a power source and press the "Cold"
button (fig. 3 A2, page 4).
✓
The operating display lights up and the device begins cooling.
The device does not switch off automatically when cooling. Because the
device cools drinks up to 22 °C below the ambient temperature, the drinks can
freeze. When using glass containers, ensure that they are not cooled for too
long as otherwise the liquid will freeze and the glass will break.
➤
If you wish to end cooling, press the "Off" button (fig. 3 A, page 4).
➤
To switch off the device, pull out the connecting cable.
7.2 Heating drinks
You must open the drinks bottle before heating. The drink expands as it heats
and can burst the bottle if it is not open.
➤ If you want to heat drinks, connect the device to a power source and press the "Heat"
button (fig. 3 A2, page 4).
✓
The operating display lights up and the device begins heating.
✓
The device stops heating automatically when the drink has been heated to a temper-
ature of around 60 °C . This prevents the device from overheating.
It warms the drink again if the temperature falls.
➤
To end heating, press the "Off" button.
➤ To switch off the device, pull out the connecting cable.
7.3 Connecting to the cigarette lighter
If you connect the device to the cigarette lighter, remember that the ignition
must be turned on to supply it with power.
12
MF-1F