Kratki.pl ALPHA Notice D'emploi page 4

EN
1. Dimensions and weight of biofires
table no 1, Drawing no 1.
2. General information
for problem-free fireplace operation and long usage, please take note of the information below.
fireplaces may only be exchanged or returned if unused and in their original packaging.
Setting and Safety
As with any product which is used for burning, a bio-fireplace produces heat. therefore, it should be
located in a suitable place far away from inflammable materials. It should be situated at least 40 cm
away from any furniture. Children and pets should stay a safe distance away from fire. Wall assembly
is possible on condition that fire regulations, applicable in this place, are respected. It is recommen-
ded that fire-resistant coat be used on a wall within the range of fireplace assembly works in order to
avoid scorching of the wall. Bio-fireplace uses oxygen, therefore it is necessary to ventilate the room.
Starting the fire
these fires are only suitable to burn bioethanol (we recommended bio-deco). Using other materials
or substances may lead to the damage, fire, severe injury or health damage.
Combustible inserts should be filled maximally up to three quarters of height. the fire should only be
started by a competent adult, respecting all safety regulations. fuel should be fired only in designa-
ted containers by long fireplace matches or lighters for gas burners.
IMPORTANT - you should avoid filling and lighting the fire appliance while it is hot (for example,
immediately after the automatic termination of the fire or after the fire has gone out). fuel poured
into a hot fire/container evaporates very quickly creating strong vapours, these may ignite and flash
causing an explosion and burning.
Extinguishing the fire
to extinguish the fire/biofuel, cut off the air supply. to extinguish the flame in the rectangular conta-
iner, you should close it by moving built-in cover.
the container with the burning biofuel will be hot, so for closing a rectangular container always use
the included poker.
Be careful, the bio- fire, and the immediate surroundings may stay hot for some time after use.
3. ASSEMBLY INSTRUCTIONS
After installing/setting bio-fireplace in place, it should be placed there container for biofuel.
a) ALPHA, BRAVO, BRAVO 2, CHARLIE, CHARLIE 2, JULIET, JULIET 1100, JULIET 1500, OSCAR
Above biofire models are designed for mounting on the flat wall (mounting kit included) or built in
the indicated hole on the wall. Installation involves putting the bio-fire in a prepared hole, which is
cut in the wall or made in construction slabs (eg G-K fireproof panels). Use the mounting screws (set
included) to assembly biofire. Dimensions of the hole adapted for bio-fire presented in table no 2.
setting the bio-fire is presented in drawing no 2.
b) DELTA, DELTA 2, GOLF, MILA, QUAT
Above biofire models are designed for mounting on the flat wall (mounting kit included) or built in
the indicated hole on the wall. Installation involves putting the bio-fire in a prepared hole, which is
cut in the wall or made in construction slabs (e.g. G-K fireproof panels).
Use the mounting screws (set included) to assembly biofire.
Dimensions of the hole adapted for bio-fire presented in table no 3.
setting the bio-fire is presented in drawing no 3.
c) MISA, INDIA, FOXTROT, KILO, HOTEL KRZAK, NOVEMBER, ROMEO, PLANET, LEGIONIS, DECEM-
BER, QUAERERE, EGZUL, JANUARY, FEBRUARY, OCTOBER, SIERRA, JULY, MARCH, APRIL, MAY
biofire are freestanding units-do not require assembly.
4