Technical Data; Sound And Vibration; Before Starting The Equipment - EINHELL BG-CS 235 E Mode D'emploi D'origine

Anleitung_BG_CS_235_E_SPK7:_
GB

5. Technical data

Rated voltage:
Power input:
Idle speed:
Adjustment angle:
Grinding wheel Ø (inside):
Grinding wheel Ø (outside):
Grinding wheel thickness:
Protection class:
Weight:

Sound and vibration

Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Grinding
Vibration emission value a = 3,675 m/s
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
The specified vibration value can be used for initial
assessment of a harmful effect.
Keep the noise emissions and vibrations to a
minimum.
Only use appliances which are in perfect working
order.
Service and clean the appliance regularly.
Adapt your working style to suit the appliance.
12
23.11.2011 15:46 Uhr
Do not overload the appliance.
Have the appliance serviced whenever
necessary.
230V 50Hz
~
Switch the appliance off when it is not in use.
235 watts
Wear protective gloves.
-1
3000min
Residual risks
40º to the left and right
Even if you use this electric power tool in
22 mm
accordance with instructions, certain residual
max. 145 mm
risks cannot be rules out. The following hazards
3.2 mm may arise in connection with the equipment's
construction and layout:
I
1. Lung damage if no suitable protective dust mask
5.8 kg
is used.
2. Damage to hearing if no suitable ear protection is
used.

6. Before starting the equipment

The entire assembly process may only be carried out
68,3 dB(A)
after the power plug has been pulled.
3 dB
Fitting the grinding head (Fig. 3a/3b)
81,3 dB(A)
The equipment consists of the grinding head (10)
3 dB
and the base frame (11) which must still be fitted.
Insert the centering pin of the grinding head into the
opening of the base frame. Now insert the hexagon
head bolt (A) from the front through the hole in the
grinding head and the oval hole in the base frame
and secure on the back with a washer (B) and a star
screw (C).
2
Fitting the handle (Fig. 4)
Screw the handle (13) into the intended hole on the
grinding head (10).
Mounting on a table or wall (Fig. 5/6)
The equipment is designed for both table top
installation and wall mounting.
When installing the equipment on a table top, first
make sure that the edge of the equipment is flush
with the edge of the table, then secure the
equipment with the holes (A).
When mounting the equipment on the wall, use the
holes (C) to secure the equipment. Spacer sleeves
or the like should be used so that the roof cutting
angle set screw remains accessible.
When mounting the equipment on a wall, make sure
that it is not fitted too high so as to avoid working at
eye level.
Seite 12