Instructions For Use; Cooling - BALAY 3XP 20 Série Mode D'emploi

Cooling

Instructions for use

Plug your appliance in.
Lead the hot-air expulsion duct outdoors, fig.
Set to maximum
Turn the drainage stopcock to the cooling position,
fig. 5 .
Set the thermostat, fig.
temperature. Should the appliance turn itself off by
thermostat, it will not come back on again until room
temperature goes up 2-3°C.
The appliance lowers the temperature and dries the
air in the room at the same time in order to create
ideal air conditions.
Condensed water formed during air conditioning
evaporates automatically and is expelled outdoors,
together with hot air, through the hot-air expulsion
duct.
In conditions of extreme humidity, the appliance
accumulates water in an internal tank. When the water
in this tank reaches a certain level, safety pilot light
15 comes on, indicating that the tank needs to be
emptied. To do this:
Turn the appliance off (setting 0, fig.
minutes for the safety systems to reset.
Turn drainage stopcock 11 90° in an anti-clockwise
direction, fig.
11
Remove the plug from stopcock 10 and insert
drainage pipe 4.
Place a bowl at the drainage pipe outlet to collect
the condensed water in, fig.
Set the appliance to either the cooling or
dehumidification position.
Warning!
Do not forget to put the plug back in place on the
drainage stopcock and to turn the stopcock 90° in
a clockwise direction before setting the appliance
to the temperature control setting. The appliance
will shed water if you fail to do so.
You have now removed all the excess water from
the system and can turn the appliance back on
and use as normal.
31
or silent cooling.
4 , to the desired
.
.
12
.
7
6
) and wait 10