Installing The Cooker Hood - Sirius S-DD18 Instructions D'utilisation Et Avis De Montage

INSTALLING THE
COOKER HOOD
1. Before carrying out the appliance installation,
please check that all components are not da-
maged, in such a case contact your retailer
and do not carry out any installation operation.
Remove safety packing before the installa-
tion of the downdraft. Furthermore, please
read carefully all of the following installation
instructions.
● Use an air exhausting pipe whose maximum
length does not exceed 5 meters.
● Limit the number of elbows in the piping,
since each elbow reduces the air capacity of
1 linear meter. (Ex.: if you use no. 2 x 90° el-
bows, the length of piping should not exceed
3 meters).
● Avoid abrupt direction changes.
● Use a 150 mm. constant diameter pipe for
the whole length.
● Use piping approved by standards in force.
The manufacturer shall not be deemed re-
sponsible for air capacity or noise problems
caused by failure to comply with the above
instructions and no warranty on the product
shall be provided.
2. Before making the hole, check that there are
no structural or other parts inside the cabinet,
where the appliance is to be placed, which
could hinder a proper installation.
Check that the dimensions of the Downdraft
and the ones of the cook top are compatible
with the cabinet so that the installation can be
carried out properly.
3. Make a rectangular opening, 826x108 mm in
size, in the back of the cook top for the 90 cm
model.
4. Put the Downdraft in the opening, inserting it
from above as shown in (Fig. 1).
S-DD18
EN
5. Secure the product inside the furniture by
using the specific brackets provided.
Proceed to the installation of the brackets in
the sides of the product, in the specific hooks,
as shown in fig. 2.
Then tighten the screws manually, as in fig. 3,
to secure the product to the furniture.
Before tightening the screws, make sure that
the product is perfectly balanced. Pay atten-
tion in order not to tighten the screws too
much.
6. In the version of the Downdraft equipped with
internal motor, install the power unit orienting
the air outlet to the desired position, either
downwards or upwards (Fig. 4).
The motor can be installed either on the front
or rear side of the downdraft After having in-
stalled the motor, connect the air ducts.
7. For versions with external motor, place the
suctioning unit (external motor) in a suitable
area and fit the exhaust air flue as illustrated.
Then fit the air outlet ducts between the ex-
ternal motor and the downdraft. Select an air
outlet from the five possibilities (Fig. 5) and fit
the union supplied with the appliance.
8. Place the metal box with the electronic com-
ponents in an easily reachable area for even-
tual technical assistance operations. (Fig. 6),
connecting the three connectors (9 pole con-
nector for the actuator control and the safety
control, 4 pole connector for neon lamp turn
on and push-button connector) (Fig. 7).
9. For motors, connect the motor unit cable to
the relevant connector on the elec-trical com-
ponents box. (fig. 8).
10. Power the cookerhood.
11. Take the glass frontal from the packaging and
connect its cable into the downdraft, as shown
in fig. 9.
Install the glass frontal making sure that the
magnetics parts, of the downdraft, match the
holes in the back of the glass frontal.
17