Transporting/Storage - Honda Power Products WB20XT Guide De L'utilisateur

9. TRANSPORTING/STORAGE

• To avoid severe burns or fire hazards, let the engine cool before
transporting the pump or storing it indoors.
• When transporting the pump, turn the fuel valve to the OFF
position, and keep the pump level to prevent fuel spillage. Spilled
fuel or fuel vapor may ignite.
Before storing the pump for an extended period;
1. Be sure the storage area is free of excessive humidity and dust.
2. Clean the pump interior.....
Sediment will settle in the pump if it has been used in muddy or
sandy water, water containing heavy debris.
Pump clean water through the pump before shutting down or
impeller may be damaged when restarting. After flushing, remove
the pump drain plug, drain as much water as possible from the
pump housing and reinstall the plug.
3. Drain the fuel.....
<WB20XT>
a. Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
b. Move the fuel valve lever to the OFF position, loosen the
carburetor drain bolt by turning 1 to 2 turns counter clockwise
and drain the fuel in the carburetor.
c. Remove the sediment cup, and then move the fuel valve lever to
the ON position and drain the fuel in the fuel tank.
d. After all fuel has drained into the container, tighten the carburetor
drain bolt securely.
e. Reinstall a new O-ring and sediment cup.
f. Move the fuel valve lever to the OFF position.
PUMP DRAIN PLUG
26
WASHER
DRAIN
SCREW
FUEL VALVE LEVER
O-RING (Replace)
SEDIMENT CUP