Quinny zapp Xtra CV217 Mode D'emploi page 11

15
Removing Fabric Seat
NOTE: Before you begin, remove seat from stroller
frame. Canopy stays attached to fabric seat.
Open canopy and unzip to reveal a tube underneath
(Figure 15). Remove fabric from canopy tube.
Flip seat over and unfasten four grey tabs (Figure 15a).
Pull each grey tab to remove four tubes from the seat
(Figure 15a).
16
Reattach Fabric Seat
Position seat frame and fabric facing up on a flat surface
(Figure 16). Slide seat supports into the fabric pocket as
shown.
NOTE: Tubes and channels labeled 1 through 4 must
match (Figure 16a).
Slide fabric into slot channel of the seat frame (Figure
16b).
While holding fabric in frame channel, slide tip of tube
labeled 1 into frame channel labeled 1. Continue to
slide tube into fabric channel as well as frame channel
(Figure 16c). Repeat with tubes 2, 3 and 4.
Fasten four clips (Figure 16d).
Fit canopy fabric around canopy tube and zip canopy
fabric into place (Figure 16e).
16a 16b
2
TM
16c
3
15
1
15a
5
4
4x
4x
16
16d
5
4
11
4x
To Use
2
7
6
Seat
Seat
Supports Supports
1
16e
4x
6
3
7