Numatic NV - 450 Mode D'emploi page 9

Information for DRY USE Vacuum Cleaners
Ensure you read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of these machines, as with all electrical
equipment, care and attention must be exercised at all times during use, you must also make
certain that routine and preventative
maintenance is carried out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to the correct
standard could render this equipment unsafe and the manufacturer can accept no responsibility in
this respect.
This machine is for DRY USE only
You must disconnected the machine from the mains by removing the plug from the supply socket
BEFORE cleaning or maintenance and when replacing parts or converting the machine to another
function.
This appliance is intended to be assembled, cleaned and maintained by an adult.
This machine is not suitable for the collection of biological hazards, hazardous or explosive dusts.
Contact your local distributor if you require a machine capable of performing these tasks.
The machine must not to be used by persons with reduced physical, sensory or mental
capabilities, or lack of experience or knowledge, unless they have been given supervision or
instruction.
You must not allow the supply cord to come into contact with rotating brushes (if fitted).
Only use the socket outlet on the machine for purposes specified in the instructions (where fitted).
This machine is not a toy; children shall not play with this machine.
This machine must not be stored outside, or used in wet environments, or to collect wet materials.
The vacuum cleaner should be stored in a dry place and is for indoor use only.
You must ensure that the filtration system fitted to the machine is suitable for the material being
collected.
This product complies with the requirements of IEC 60335-2-69.
This machine is suitable for commercial use, for example in hotels, schools, hospitals,
factories, shops and offices for other than normal housekeeping purposes.
If the vacuum cleaner stops working, remove the plug from the wall before investigating where the
fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the socket outlet, and
inspect the floor tool, wands and hose for debris. If the floor tool, wands and hose are clear,
replace the dust bag and clean the filter.
The vacuum cleaner should be inspected after use for damage.
244042 04/16 (A06)