Connecting To The Power Supply; Basic Operation; Dab Operation - LENCO SCD-685BK Mode D'emploi

CONNECTING TO THE POWER SUPPLY

1. Connect the end of the detachable power cord to the unit rear panel AC IN ~ jack and the other end to the AC outlet.
2. Press the STANDBY button to turn on the unit.
DC CONNECTION
For DC operation, firstly remove the AC plug from the AC outlet and disconnect the AC cord from the AC IN ~ jack. Then
insert 6 pcs size C (UM-2) batteries into the battery compartment.
Since the unit will draw little power consumption even in Standby mode, it is suggested to uninstall the battery when it is
not used for a long time.

BASIC OPERATION

Press the STANDBY button to turn on the unit. To turn off, press and hold the STANDBY button again.
DAB/FM/CD/USB/SD/BT/AUX
Press the SOURCE button to select from different sources.
Volume Control
Press the VOL-/VOL+ buttons to change the volume.
Adjusting the Antenna
The telescopic antenna should be extended to ensure a good FM reception. Alter the antenna position for the best
reception.

DAB OPERATION

The first time the unit is in DAB mode, it will automatically scan for DAB available stations. Wait for a while until the
scanning is finished. The display will show the scanning progress. After scanning it will tune to the first station. Stations are
listed in numerical then alphabetic order. All stations scanned are stored. The next time the unit is turned on there will be
no automatic scanning.
Auto Scan
1. Turn on the unit in DAB mode.
2. Press the SCAN button to start auto-scanning the available stations.
Manual Scan
1. Turn on the unit in DAB mode.
2. Press MENU button to access the menu control.
3. Press the TUNE- or
4. Press the TUNE- or
5. To select another channel (5A-13F), press the
6. Press ENTER to confirm.
TUNE+ button until "Manual tune" is displayed and then press the ENTER button.
TUNE+ button to select the desired channel (5A-13F).
TUNE- or TUNE+ button.
11