Check Actuators On The Output Module - Aventics EtherNet/IP Mode D'emploi

AVENTICS | EtherNet/IP™ | R412012728–BDL–001–AC
7.4.3

Check actuators on the output module

Before commissioning, check the actuator function and the method of operation
using the LED displays on the output module.
O O
O O
O O
O
O O
Fig. 15: LED displays on the M8 output module (left) and M12 (right)
Table 17: Meaning of the LED displays on the output module
LED Color Meaning
U Green Load supply U
Q1
Red Diagnosis: Overload/short circuit of controlled output O0,
O1, O2, or O3
Off Load supply U
U Green Load supply U
Q2
Red Diagnosis: Overload/short circuit of controlled output O4,
O5, O6, or O7
Off Load supply U
O0 to O7 Off Corresponding LOW level output
Yellow Corresponding HIGH level output
Commissioning and Operation
O
available
Q1
not available (e.g. emergency OFF)
Q1
available
Q2
not available (e.g. emergency OFF)
Q2
69