Fonexion ideus ITCAB400 Guide D'utilisation page 19

USER GUIDE
SETTING ALARM CLOCK
In on-hook state, press ALARM/P key once, LCD displays 12-00 AL1,
Press ▲ or ▼ key to select ON or OFF. LCD displays ALM icon when the alarm is set
to ON.
Press SET key, value "12" starts to flash.
Press ▲ or ▼ key to set the alarm hour and press SET key to confirm and enter alarm
minute setting.
Press ▲ or ▼ key to edit alarm minute and press SET key to confirm and go to next
group alarm clock setting.
Repeat the above steps to set additional alarms.
Note: The first 3 groups alarm clock will be repeated periodically every day while the last 2
groups alarm clock is effected one time.
SECRET CODE SETTING AND REMOTE MONITOR FUNCTION
Setting
In on-hook state, press and hold HOLD/RING key for 3 seconds, LCD displays Pin ----.
Input a 4-digit of PIN using the numerical keys.
Press DEL to edit the secret code, press SET to confirm.
When the last digit of secret code is #, the telephone will activate remote monitor function.
Set the ringing volume to dB0. (Please refer to section "SETTING RINGING TONE").
Usage
Secret code: When caller calls this telephone, he/she will hear the usual ringing tone (when the
line gets through) three or four times from telephone line. However, the telephone unit will not
ring. Then the caller will hear a short "di" sound, which means that the caller need to key in the
secret code. Once the caller keys in the correct code, the telephone unit will ring. Press key or
pick up the handset to have the conversation with the caller.
Remote monitor: If the last digit of the secret code is #, after the caller keys in the correct secret
code, the telephone unit will go into hands free mode automatically. The caller can hear the
sound around the telephone unit.
If the caller keys in the wrong code, he/she will have to call again and key in the correct secret
code PIN.
Note: This function is useful only when the telephone ringer is set to OFF. The caller must know
the secret code in order to dial through the line.
TRANSFER BETWEEN PARALLEL PHONES
Setting paging number
In on-hook state, press and hold SET key, LCD displays EL--
Key in "*" and the paging number (example "*1"and "*2" ), using DEL key to edit
Press SET key to confirm and exit.
Transferring the line from paralleled phones:
When a call comes, use one of paralleled phones to answer. Press "*" and the paging number
that was set in another telephone unit (the operation should be done within 30 seconds after
you answer the call using the parallel phone. If the time is more 30 seconds, the transfer
operation is not available), the unit rings, pick up its handset or press HANDSFREE key to
answer the incoming call.
ITCAB400
19
EN