Levelling The Appliance; To Fit The Language Insert (Program Selection) (Pt 8303 Only); Payment System; Communication Module Xkm Rs232 - Miele professional PT 8301 SL Mode D'emploi

Installation and connection

Levelling the appliance

The dryer does not require a plinth. However, make
sure that any uneven areas of the floor are made le-
vel.
The dryer must be perfectly level to ensure that it
functions correctly.
The screw feet A can be adjusted to align it.
After aligning the dryer correctly you need to use a
screwdriver to secure discs B to the floor plate.
^ Secure the front feet of the dryer with the clamps
supplied.
^ Follow the installation instructions supplied.
20
To fit the language insert (program
selection) (PT 8303 only)
Remove the protective cover on the control panel.
Carefully lift up the lower area of the control panel co-
ver underneath the program jog shuttle slightly.
Push in the language insert and align it.
Remove the dividers which are located underneath
and press the control panel cover down.
Reducing the noise level
This dryer is fitted with an exhaust fan which can be
heard during operation.
If this noise disturbs you it is possible to fit a silencer
(available from Miele as an optional accessory) into
the dryer's exhaust duct (see Installation instructions).

Payment system

All COP models are fitted with a connection for a coin
control unit.
Empty the coin box every day. This prevents too
many coins or tokens collecting in the coin box,
which could lead to the dryer breaking down.

Communication module XKM RS232

This dryer can fitted with a communication module
which enables it to be linked to a PC via a serial inter-
face.
The slot for the communication module is located on
the rear of the dryer.
An editor program is available from Miele.