Filter Closing; Starting; Working - aqua AQUARIUS 6m3/h Manuel D'utilisation Et D'entretien

22.6

FILTER CLOSING


Close the filter by the lid, the gasket, the clamp, the screws and the nuts included in the
equipment

Verify that the contact surfaces are clean and eventually remove the dirt or the residual
filtering material;

Place the gasket on the filter.

Assemble the pressure gauge on the lid in the proper hole (by the threaded hole or by
the proper back nut and O-ring);

Place the lid

Put the clamp to close the lid and the filter top

Place the 2 nuts in the clamp

Close the clamp using the screws, until the two side are coincident. Do not over-screw!
22.7

STARTING

Open slowly the valves situated on the connection pipe.
Check that there are no water leaks.
ATTENTION:
22.8

WORKING

The equipment carries out the filtration of the water according to what is described in this
handbook. For a good performance of the filter and for a good management of the system
connected to it, there are further functions that should be considered and suggested.
By a different set up of the multi-port valve connected to the filter (when models are included) it
is possible to carry out these other functions.
A 6 way valve has the following main working positions:
the operating conditions of each position are described in detail hereafter
- '
MANUALE D USO E MANUTENZIONE
L0200200 R .3 15/02/2017
EV
In case of water leaks, close immediately the filter valves and
proceed with an examination of the system.
1 - filtration
2 - backwash
3 - rinsing
4 - waste
5 - circulation
lock
6 -
–
INSTRUCTION AND MAINTENANCE MANUAL
L– '
MANUEL D UTILISATION ET D
' 24
ENTRETIEN