Structural Data And Technical Characteristics; Equipments Technical Characteristics; Risks Connected To The Equipment; Universality - aqua AQUARIUS 6m3/h Manuel D'utilisation Et D'entretien

18.3

STRUCTURAL DATA AND TECHNICAL CHARACTERISTICS

The main indications concerning the equipment's characteristics are given hereafter.
18.4
EQUIPMENT
The dimensions, the
reported on the component cards enclosed at the end of this handbook - picture 13.1 –
Filters should operate only with:
aqueduct or ground water
-
- seawater;
- water mixed with sodium hypochlorite in compliance with the UNI 901:2002 rule in a
solution of max 0,2 mg/l ( 2 ppm).
The equipment can be submitted to the working pressure of:
ATTENTION:
The fluid temperature used by the equipment should be included in the following range:
ATTENTION:
RISKS CONNECTED TO T HE EQUIPMENT
19
19.1

UNIVERSALITY

For its own conformation, for its structural prerogatives and for the work that should be
accomplish, the equipment shows some not eliminable risks hereafter described.
19.2

CONNECTED RISKS

Reference Risk
Fluids'
1
projection
- '
MANUALE D USO E MANUTENZIONE
L0200200 R .3 15/02/2017
EV
'
S TECHNICAL CHARACTERISTICS
bulks, the connection dimensions and the weights of the different filters are
Before the installation check that the inlet system, connected to the
filter, is provided with suitable devices which limit and prevent the
overflow of the maximum pressure inside the filtration system (4
bar).
T
If it is provided that the fluid temperature can go below the freezing
point, isolate the equipment from the inlet system connected to it
and empty it, according to the conditions specified in the
maintenance section.
sign
–
INSTRUCTION AND MAINTENANCE MANUAL
1,5 bar
T : +5°C
min
: +40°C
max
danger location
Zone surrounding the
equipment
L–
MANUEL D
remedy
sign
' '
UTILISATION ET D ENTRETIEN
20