Fm Operation; Scanning For Stations - LENCO MC-148 DAB+ Mode D'emploi

FM OPERATION

Switch to the FM mode.

SCANNING FOR STATIONS

1. You can scan up or down the frequency range manually by pressing
the buttons on the remote or pressing
/
unit to increase or decrease the frequency in 0 .05 MHz increments.
To scan through the frequency range quickly press and hold the
buttons on the unit or press the
2. Once a station has been found, the scanning will stop automatically.
If no station is found, then the tuning will stop once it has cycled
through the entire FM band (87.5-108MHz).
SCAN MODES
When performing an scan, you can set the sensitivity level of the
stations to be found. E.g. : Strong stations only or All stations.
1. In FM mode, press the STOP/MENU button, when <Scan setting>
appears on the display press the ENTER or PLAY/PAUSE button to
view the submenu.
2. Use either
<All stations> (which will detect any stations, even with a weak
signal) or <Strong stations only> (which will only detect stations
with a good signal strength). Press the ENTER or PLAY/PAUSE
button to select the required option.
3. When you perform a scan as described above, only stations fitting
the applied setting will be detected.
STORING STATION PRESETS
It is possible to store up to 10 of your favorite stations.
This will enable you to access your favorite stations quickly and easily.
1. To store a preset, you must first be listening to the station that you
would like to save.
2. Then press and hold one of the numeric buttons from 1-0 to store
the station under that number. You will see Preset X Stored appear
on the display with X being the number you stored the station under.
on the unit,
/
buttons on the remote control.
/
on the remote to select either
/
12
buttons on the
/
/