11 -First Switching-On; 12 -Use Of The Machine; Machine Statuses; Manual Switching-On - Gaggia CONCETTO ER Mode D'emploi

11 - FIRST SWITCHING-ON
- Fill the hopper (6) with the selected coffee beans blend.
Be sure the coffee does not contain foreign bodies which
could be dangerous for grinders.
- Check if the removable components (12 and 16) are in the
right position and if the door (14) is closed.
If they are not, when the machine is switched-on, the di-
splay will indicate which component is in the wrong posi-
tion.
- Turn the all-pole switch on "I".
- Switch on the machine through the switch (18);
the message "WARMING UP" will be displayed.
- When the message "READY FOR USE" is displayed :
- Adjust the brew group (22) to obtain the suitable height
depending on the container used (Pr. 8.4).
- Place one or two containers under the brew group.
- Select the beverage and press the corresponding button.
Although buttons are previously programmed on a
standard base, check your beverage has the selected
features. If not, they must be reprogrammed (Pr. 12.6).
12 - USE OF THE MACHINE
Read carefully this brochure until you get a good
understanding of the machine, before starting to opera-
te it.
After a long time of machine inactivity, read the previous
paragraph "First switching-on" before re-operating the
machine.
CONCETTO ER CONCETTO ER CONCETTO ER CONCETTO ER CONCETTO ER
12.1

Machine statuses

With regard to the power supply, the machine can have the
following statuses:
Off and electrically insulated
- Main switch (18) and all-pole switch on the "0" position
(or plug disconnected).
- Only the memory for the programmed data storing is ena-
bled.
On
- Main switch (18) and all-pole switch on the "I" position (or
plug connected).
- All the functions are enabled and the display (8a) is on.
In standby mode (machine switched off but not electrically
insulated):
- Main switch (18) is on "I" position.
- The following functions are enabled: "AUTOM. SWITCHING-
ON", "ANTI-FREEZING", if selected, and "CLOCK", as well
as the display and the memory for the programmed data
storing.
- The display's backlight is off.
12.2

Manual switching-on

This switching-on is necessary when the machine is in the "off
and electrically insulated" status (Pr. 12.1). Proceed as explai-
ned is Pr. 11 excluding, in case, the beverage brewing check.
12.3 Programmed automatic
switching-on
The machine has to be on "STANDBY" and the function
"AUTOM. SWITCHING-ON" has to be enabled.
The machine will automatically switch-on at the programmed
time.
12.4

Stand-by temporary switching-on

Manual switching-on when the machine on "STANDBY".
Press and hold the button
The machine will automatically return on "STANDBY", 60 mi-
nutes nutes nutes nutes nutes after the last operation.
36/124
English
for 3 seconds.
60 mi- 60 mi- 60 mi-
60 mi-