Installation Instructions; Charging The Internal Battery Of The Instant Power - Schumacher Electric INSTANT POWER IP-75 Guide D'utilisation

3. PREPARING TO USE THE INSTANT POWER
WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is
well ventilated while the Instant Power is
being used.
3.2 Clean the battery terminals before using
the Instant Power. During cleaning, keep
airborne corrosion from coming into
contact with your eyes, nose and mouth.
4. CHARGER AND AC POWER CORD CONNECTIONS
WARNING! RISK OF ELECTRIC SHOCK
OR FIRE.
4.1 The Instant Power charger is for use on
a nominal 120 volt circuit. The plug must
be plugged into an outlet that is properly
installed and grounded in accordance
with all local codes and ordinances.

5. INSTALLATION INSTRUCTIONS

5.1 Remove all cord wraps and uncoil the cables prior to using the Instant Power.
6. FEATURES

7. CHARGING THE INTERNAL BATTERY OF THE INSTANT POWER

IMPORTANT: CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS TO KEEP
THE INSTANT POWER'S INTERNAL
BATTERY FULLY CHARGED.
7.1 Use of an improper extension cord to
charge the Instant Power could result in a
risk of fire and electric shock. Make sure:
• That the pins on the plug of the extension
cord are the same number, size and shape
as those of the plug on the Instant Power.
• That the extension cord is properly wired
and in good electrical condition.
1 2 3
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual
and make sure that the output voltage of
the Instant Power is correct.
3.4 Make sure that the Instant Power cable
clips make tight connections.
The plug pins must fit the receptacle
(outlet). Do not use with an ungrounded
system. NOTE: Pursuant to Canadian
Regulations, use of an adapter plug
is not allowed in Canada. Use of an
adapter plug in the United States is not
recommended and should not be used.
1. Charged/Charging LEDs
2. Battery Status LEDs
4
3. Battery Status Button
4. 12V DC outlet
• That the extension cord has a wire size of
18 gauge (AWG) [0.82 mm
is 50 feet (15.24 meters) long or less.
7.2 To reduce the risk of electric shock, turn
off and/or unplug the Instant Power before
attempting any maintenance or cleaning.
Simply turning off the controls will not
reduce this risk.
7.3 When charging the internal battery, work
in a well-ventilated area and do not
restrict the ventilation in any way.
• 4 •
] or larger and
2