Buttonhole Foot - SilverCrest SNM 33 B1 Instructions D'utilisation Et Consignes De Sécurité

Buttonhole foot

Stitch length
A B
E
0.3
C D
Stitch Stitch width
Preparation:
Remove the presser foot and attach the buttonhole
foot (d). Adjust the stitch length dial (5) to between
"0.3" - "1". The density of the stitch depends on
thickness of the fabric.
Note: Always test sew a buttonhole.
To prepare the fabric:
Measure the diameter of the button and add 0.3cm
(1/8") for the bartacks. If you have a very thick
button, add more to the diameter measurement.
Mark the position and length of the buttonhole on
the fabric. Raise the needle to its highest position.
Position the fabric so that the needle is on the mark
that is furthest from you.
Push the buttonhole foot (d) towards you as far as it
will go. Lower the foot.
A. Turn the stitch selector dial (6) to "
moderate speed until you reach the end mark.
Raise the needle to its highest position.
B. Turn the stitch selector dial (6) to "
5-6 bar tack stitches. Raise the needle to its
highest position.
C. Turn the stitch selector dial (6) to "
the left side of the buttonhole to the mark at the
end which is further from you. Raise the needle
to its highest position.
D. Turn the stitch selector dial (6) to "
few bar tack stitches. Raise the needle to its
highest position.
Lift the foot. Remove the fabric from under the foot
and separate the threads. Draw the upper thread
through the fabric to the ear and knot the upper and
lower threads. Cut the centre of the buttonhole with
the stitch ripper (n), being careful not to cut the
stitches on either side.
Tips:
- Slightly reduce upper thread tension (3) to
produce better results.
- It is recommended that you use a backing
material such as yarn or fleece for fine, stretchy
or knitted fabrics. The zigzag stitch must sew over
the yarn (E).
Sewing basics
Stitch length
5 0.3~1
". Sew at
" and sew
" and sew
" and sew a
GB / IE 85