Makita DCG180 Manuel D'instruction page 6

Overload warning lamp
► 1. Warning lamp
The warning lamp flickers in red when the tool is over-
loaded. If the load reaches some point, the lamp keeps
lighting in red and the tool stops. To restart the tool,
release the trigger and pull the trigger again.
NOTE: Check what causes the overload when the
lamp flickers or lights up. Change the parameter of
the speed adjusting dial lower, or increase the diame-
ter of the nozzle.
Switch action
CAUTION:
• Before inserting the battery cartridge into the
tool, always check to see that the switch trigger
actuates properly and returns to the "OFF"
position when released.
• When not operating the tool, push the trig-
ger-lock button from A side to lock the switch
trigger in the OFF position.
B
► 1. Lock lever 2. Switch trigger
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To start the tool, push the trigger-lock button from B side
and pull the switch trigger. Tool speed is increased by
increasing pressure on the switch trigger. Release the
switch trigger to stop.
After use, press in the trigger-lock button from A side.
1
1
2
Lighting up the lamp
CAUTION:
• Do not look in the light or see the source of light
directly.
1
► 1. Lamp
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp goes out approximately 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
• When the tool is overheated, the lamp flickers.
Cool down the tool fully before operating again.
Drip preventive function
The motor keeps running for a short time even after the
trigger is released. It releases the pressure of the caulk-
ing material and prevents dripping.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
A
the battery cartridge is removed before carrying
out any work on the tool.
• Always place the tool on the ground or work-
bench when carrying out any assembling work.
The tool without being held tight may loose
balance and cause injury.
6 ENGLISH