LENCO PDR-015 Mode D'emploi page 5

 Devices with class 1 construction should be connected to a main
socket outlet with a protective earthed connection.
 Devices with class 2 construction do not require a earthed
connection.
 Always hold the plug when pulling it out of the main supply
socket. Do not pull the power cord. This can cause a short circuit.
 Do not use a damaged power cord or plug or a loose outlet. Doing
so may result in fire or electric shock.
28. If the product contains or is delivered with a remote control
containing coin/cell batteries:
Warning:
 "Do not ingest battery, Chemical Burn Hazard" or equivalent
working.
 [The remote control supplied with] This product contains a
coin/button cell battery. If the battery is swallowed, it can cause
severe internal burns in just
2 hours and can lead to death.
 Keep new and used batteries away from children.
 If the battery compartment does not close securely, stop using
the product and keep it away from children.
 If you think batteries might have been swallowed or placed inside
any part of the body, seek immediate medical attention.
29. Caution about the use of Batteries:
 Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
 Battery cannot be subjected to high or low extreme temperatures,
low air pressure at high altitude during use, storage or
transportation.
 Replacement of a battery with an incorrect type that can result in
an explosion or the leakage of flammable liquid or gas.
 Disposal of a battery into fire or a hot oven, or mechanically
crushing or cutting of a battery, that can result in an explosion.
 Leaving a battery in an extremely high temperature surrounding
environment that can result in an explosion or that leakage of
flammable liquid or gas.
 A battery subjected to extremely low air pressure that may result
in an explosion or the leakage of flammable liquid or gas.
 Attention should be drawn to the environmental aspects of
battery disposal.
INSTALLATION
•
Unpack all parts and remove protective material.
•
Do not connect the unit to the mains before checking the mains
voltage and before all other connections have been made.
5