Bresser Junior 8855001 Mode D'emploi page 14

Experiments
Use the following web link to find interesting
experiments you can try out.
http://www.bresser.de/downloads
Microscope accessories can be found here:
http://www.bresser.de/P8859480
How do I install the MicrOcular?
Note:
The MicrOcular only works without the includ-
ed Barlow lens! The magnification setting is
changed when the MicrOcular is used, and it
must be readjusted with the focus knob.
First, remove the Barlow lens (Fig. 4, 3) with
the current eyepiece from the eyepiece support
(Fig. 4) and place the MicrOcular (Fig. 5, 4) in
the eyepiece (Fig. 5).
Fig. 4
f
D
14
How do I install the software?
1. Y ou can download the setup file for installa-
tion here:
www.bresser.de/download/CamLabLite_Junior
2. Start the installation with a double click on
the .exe file and follow the instructions of the
installation manager.
3. It is not necessary to install a special driver.
The camera is automatically recognized by
your Windows operating system.
Fig. 5
Using the MicrOcular
E
Preparation
1. Slide a specimen under your microscope and
F
focus on it.
2. Remove the eyepiece and Barlow lens from
the eyepiece support and the dust cap from
your MikrOkular and then install the MikrOku-
lar into the eyepiece support instead of the
Barlow lens.
3. Start your PC if you haven't yet and connect
your MikrOkular to the USB port of your com-
puter.
4. Start the „CamLabLite_Junior" software and
activate the camera by clicking on „USB Vi-
deo Device.
5. Click on „Snapshot" to take a picture or on
„Capture" to record a video.
6. Click on the floppy disk icon to save the
image or capture.
Troubleshooting
Error Solution
No recognizable • Turn on light
image • Readjust focus
• Check Windows privacy
settings
Image flickers • If necessary, increase
(while observing resolution of graphics
with MicrOcular) card
= Monitor • Adjust brightness at the
refresh rate not dimmer of the microscope
adequate
• Disable automatic expo-
sure